FiestaMk7.com Owners Resource

Out with the old....


...and in with the New!


Problems:
- - 1. Didn't know how I would get the AirFlow Sensor into the new housing. Had to peel back the rubber seal from the Heat Shield/Black Housing and take off the Black Electricians Tape wrapped round the wires in order for the sensor to reach.

- - 2. Rock hard to keep a hold of the Screw and the Screwdriver to put the screws back into the sensors metal bracket. (I actually dropped one and couldn't find it in the engine bay [I'll have a look in my Dad's 'Various Screws' tub])

Looks good.

Any noticable difference? Or just more noise?

[I'll have a look in my Dad's 'Various Screws' tub]

I love this ^

Looks great! I definitely put the K&N on my last car purely for noise

I only drove to the gym and back, but I am happy with it.
It isn't ridiculously loud driving normally, but when you get past 3,000rpm, it starts to really shout!
Its the right sort of noise if you are just ticking over at just over 1,000rpm on a cold start you can't tell.
If you don't give it full throttle you can't really tell either, when you put your foot right down you can't half tell. Its like it knows when you want it to make a noise.
Its like your throttle is a volume limiter.

Hope that made sense, because I was a bit nervous about investing in it.

I'll get a video or something up soon.

Ben - That's exactly why I did invest, because I had a go in a 1.25 Zetec when mine was getting serviced and it sounded almost exactly the same, if it looks the part it has to sound it!
Its supposed to give an extra 2-3mpg and 5bhp, but I wasn't too fussed with that.
I think its worth the £100 more than the K&N because of the quality.

Like how it looks but just not sure wether to get one as last time i fitted a filter to my old car fuel comsuption went right down for just a little gain :/

I'll keep you posted on fuel and noise and all that.
I get about 290-320miles before the fuel light comes on, then I brim it.

yeh let me know please if you wouldnt mind? but not sure if i can even do it now as i have just had all the airbox housing airbrushed and would spoil the look of the engine bay. What you got planned for her next?

No problem, I'll keep you updated.

Grills! Definitely need to get them taken off and painted to match the wheels.
Then I will start on getting thar horrible beige roof and pillars a different colour on the interior.

Standard Filter:
35.90L @130.9
299.4 - miles covered
39.0 - miles left.

J1 Filter:
--In progress--